Katriane Rousseau Desks April 16, 2018 22:23:32
Desks with Superstructure: very popular in Victorian times and earlier. These desks - which take many forms Dickens desks bankers desks roll top desks Carlton House Desks etc - have a raised structure at the back of the desk with drawers small cupboards or pigeon holes for stationery. Many of these desks were designed to stand against a wall and have a relatively plain or even unfinished rear elevation. Some desks have flat writing surfaces some have raised writing slopes with storage underneath - those with the slope are becoming popular again since the slope provides an ideal "work station" for a laptop computer.
L shaped Computer Desk Manufacturers - Many companies are making L shaped desks but some names are far more common. This is a short synopsis of some of the most popular names in L shaped desks.
Corner or Free Design - A corner desk is placed in the corner. Generally it is not placed in the middle of the room. The free design is the simple rectangle desk that you can place anywhere you wish. It gives you more flexibility. In future if you want to rearrange furniture and belongings in the room then you can place such a desk at a different place. The corner desk can be L-shaped or I-shaped design. If you choose a corner desk then it should have sufficient width. It is difficult to spread your legs further if a corner desk has a small width. It can put strain on your legs and body if occasionally you cannot stretch your feet in front on the floor.
Desks to be seen from all angles: as mentioned above some desks were always designed to stand against a wall. The original cabinet makers therefore spent less time finishing the rear elevation of the desk sometimes even leaving it with relatively unfinished timbers. Other desks were however always designed to make an impression on anyone entering a room and facing the person sitting behind the desk. In this instance the "rear" of the desks would be highly polished panelled and often decorated or carved. Partners’ Desks also serve this purpose in offering an interesting and usable rear facade.
Practical Matters: Access for installation - most desks are made in three pieces (two pedestals and a top) but a one piece desk or table may require need the access into the room itself to be checked (remember to check the stairs if it is going above the ground floor). Most professional furniture movers such as those employed by Antiquedesks.net can manoeuvre large piece of furnitures but sometimes it just doesn’t fit!
Sauder - Makes desks that are easy to assemble at home and are often found in stores like Wal-Mart and Office Depot. Their desks are usually made from fiber board but their high end Palladia Collection can be very sturdy and quite attractive.